Pixhawk-PPM-Encoder-PPZ-MK-MWC-MegaPirate-For-APM-Multiwii-F-light-Controller
-font-b-Pixhawk-b-font-PPV-MC-MWC-font-b-PPM-b-font-font-buz6gmjb

PPM Encoder Modifications to the R/C receiver

21.00$

In stock

SKU: RE0053 Category: Tags: , ,

Product Description

The PPM Encoder plugs into the PWM servo output ports of any R/C receiver and encodes them into a PPM pulse suitable for many autopilots  Pixhawk. Modifications to the R/C receiver are not necessary.

  • The whole project is based around the ATMEL ATMEGA328p AVR processor and all timing is done within interrupts so accuracy and stability is optimized.
  • Firmware is free and was created by John Arne and Olivier Adler.
  • The design of the PPM Encoder is based on the Paperazzi PPM Encoder.
  • Important Note: The firmware comes pre-configured to read 8 Channels. In case you would like to change the settings of the PPM encoder to invert the PPM signal and change the fail safe pre-defined values you will need an AVR ISP programmer in order to reprogram it.
  • The jumper on the board no soldering default. In this case the board powered by FC
  • Dimension(mm): 28 x 19 x 5
  • Weight(g): 9(include all wire)
  • Package content
  • PPM Encoder x 1
  • 10Pin input cable 60mm x1
  • 4Pin output cable 100mm x1

Additional Information

Weight 0.09 kg

Reviews

There are no reviews yet.

Be the first to review “PPM Encoder Modifications to the R/C receiver”

Your email address will not be published. Required fields are marked *